The tarpaulin factory introduces the storage and maintenance of tents

Since the tent uses waterproof rubber strips, if it is folded and stored, the waterproof rubber strips will be bent and pressed by external forces, which will easily cause the waterproof rubber strips to fall off. However, due to the large size of the tent, under normal circumstances, it is impossible to hang the tent for storage, so what should we pay attention to when storing the tent? 1. After the tent is used, in addition to cleaning the dust and In addition to the attachments, the moisture on both sides of the fabric should be wiped off, and it should be folded and stored after drying. This is very important. Storing it before drying can easily lead to mildew and sticking problems. 2. After the tent is folded and stored dry, try not to put other items on the inflatable tent, so as to avoid the phenomenon of degumming caused by fatigue at the bending of the waterproof rubber strip material. 3. Regularly or irregularly take out the inflatable tent to cool down (avoid direct sunlight) for half a day, rearrange it and then fold it for storage. The rubber strip will not cause sexual fatigue and prolong the overall service life of the tent. 4. After the tent is cleaned, it is not advisable to use the original storage bag for compression storage. Temporary maintenance: Wipe and dry the damaged part first, cut a piece of air-tight cloth with a circumference larger than 3cm, apply a thin and even layer of glue, and let it dry for about 10 minutes. After 20 minutes of pasting and compaction, it can be used. Maintenance of the tent: 1. Find the air leak point, that is, where the airbag is cut. 2. The surface of the same material as the airbag should be cut and the surface of the air leakage should be cleaned up. In special cases, it needs to be polished. 3. Pay attention to the viscose environment before bonding, and the operating environment must be kept clean. 4. Brush the glue evenly, with the same width and width, and there should be no leakage or accumulation of glue. 5. Strictly control the drying time during brushing. After the glue has dried, it can be brushed over, and the bonding operation can be carried out after the glue has dried. 6. After the viscose is completed, it should be parked for more than 24 hours before use.