Support and fixing of tarpaulin manufacturers-News Center-Lin-Yang dishcloth factory

After the support of the tarpaulin manufacturer and the tent of the tarpaulin manufacturer are laid out, the four corners of the inner account should be fixed first so that the bottom of the tent can be laid firmly on the ground. If conditions permit, the floor mat can be padded under the tent, this not only protects the bottom of the tent, but also achieves the best waterproof effect. When supporting the external account, in addition to the reliable connection with the Peng Rod, pay special attention to pulling the rope to make the external account tight, so that the external account can achieve the best rainproof. The tent with the skirt should be pressed with soft soil or sand, snow pressure can also be used in winter, which is more conducive to wind prevention. The fixing of the nail should have an inclination angle with an angle of 35- 45 degrees is appropriate, the distance and direction of the ground nail into the ground and the rope should be the same axis, the rope and the ground nail into a 90 degree angle, which is conducive to achieving the maximum stress strength. Attention should be paid to the corresponding fixing in the fixing sequence, for example, the Left Front angle, the right rear angle, the right front angle and the left rear angle. After the whole tent is fixed, adjust the rope pulling wire to make the pulling force consistent in all aspects. After supporting the tent, check the distance between the internal and external accounts. If it is attached together, it will affect rain and dew prevention and should be adjusted.