Precautions for bundling truck tarpaulins

1. The pressure rope at each end of the tarpaulin should be pressed tightly against the corner of the tarpaulin, so that the tarpaulin is close to the end wall of the vehicle, and tied to the first rope on the side of the vehicle respectively, and must not be tied to the tow hook. 2. The place where the rope is tied to the truck should not be tied to other parts. The tarpaulin rope should be turned into the word 'you' and then tied to the other end of the rope head. Pull the end of the rope with one hand. Fold the rope into two, and then tie it into a back flower. In other words, the rope is tied by the bow knot method or the back flower knot method. The end of the rope should be wrapped around its own rope rod, and at least two dead knots should be tied. ; The length of the head and tail of the rope shall not exceed 300mm and shall not be shorter than 100mm. 3. The waist rope should be pulled straight and tied on the side rope of the vehicle. The stretched length of the elastic part of the elastic rope should not be less than 200mm. It should be determined according to the situation of the loaded goods. If there is a rope in the middle of the vehicle, the middle waist rope should be tied to the vehicle. The ropes in the middle; if there is no rope in the middle of the vehicle, the waist ropes in the middle of the tarpaulin are respectively tied to the ropes near the middle of the vehicle, and the other waist ropes, starting from the two ends of the vehicle and toward the middle of the vehicle, are sequentially tied to the corresponding ropes. . When the elastic bar is not close to the eye rim, the elastic rope should be retracted from the middle, and the excess rope in the middle should be folded and tied with two dead knots, and the remaining end should be tied with rope clips or twine for 5 turns and tied with its own rope rod. 4. Except for the tarpaulin's own ropes and tarpaulin rope nets, no other ropes shall be used to bind the tarpaulin. 5. The plastic tarpaulin after binding should be covered and flat as a whole, the goods should not be exposed, the corners at both ends should be solid and dense, the lines should be smooth, each part should not exceed the limit, be firm and not loose and fall off. Of course, the handbrake disc of the truck must be exposed. 6. The tarpaulin corner ropes at both ends of the truck are crossed along the end wall of the truck and then tied to the two ropes at the end of the vehicle respectively. When the angle rope passes through the brake platform of the human brake of the truck, it should pass above it; when it passes through the brake lever and the hook lever, it should pass through the inside of it; at the same time, pay attention to the two end ropes in the middle of the tarpaulins at both ends of the truck, respectively. Tighten the two ropes tied at the end of the vehicle, and also pass through the inside of the hook rod when passing through the hook. The above is the relevant content about the precautions for bundling tarpaulins for trucks compiled by Xiaobian, I hope it can be helpful to everyone.

Everyone who has a pvc plastic film wants it to look clear pvc film. However, in order to achieve that, it normally involves investing in a pvc plastic film PVC Film. ZHONGSHAN LINYANG PLASTIC CO.LTD can offer you the best solution.

To discover more about the clear pvc film benefits of , go to LINYANG PVC Tarpaulin Film.

ZHONGSHAN LINYANG PLASTIC CO.LTD are used to coming up with solutions while think about problems, also expressing the whole idea individually.