Tarpaulin installation and fixing skills-News Center-Lin-Yang dishcloth factory

Tarpaulin installation and fixing skills when tarpaulin is used, sometimes there will be wind. If it is not fixed, the tarpaulin will be easily scraped off. For tarpaulin manufacturers, the tarpaulin installation and fixing skills. First of all, the plastic tarpaulin should be spread out, and then the four corners of the internal account should be fixed so that the bottom of the account can be laid firmly on the ground. If conditions permit, the floor can be padded under the account, not only can it play the role of waterproof, but also can protect the bottom of the account. When supporting the external account, in addition to being able to connect with the Peng Rod reliably, it is also necessary to pay attention to pulling the rope to make the external account tight, so that the external account can reach the best rainproof, and the account with the skirt, it can be pressed with soft soil or sand to prevent it from being blown away by strong winds. There should be an inclination angle when fixing the drip, and the point of view should be 35- 45 degrees is the best, the interval and direction of the nail into the ground and the rope should be the same axis, the rope and the nail into a 90 degree angle, so that the maximum stress strength can be reached. In the fixed order, attention should be paid to the corresponding fixing. After the whole account is fixed, adjust the rope pulling wire so that all aspects of the pulling force are common. Finally, after supporting the plastic tarpaulin, check the interval between the internal and external accounts. If it is attached together, it will affect the rain and anti-dew, and it should be adjusted in time. The above is the installation and fixing skills of tarpaulin. If there are any other problems, you can contact us at any time and look forward to your call!