Folding methods and requirements of the tarpaulins technology _ industry trends

Linyi tarpaulin factory perennial spot supply 3 m * 4 m, 4 m * 6 m, 6 m * 8 m, 8 m * 10 m, 10 m * 12 m specifications such as blue and white, LanJie, double white, green, blue, silver and other finished products tarpaulins and striped cloth, all kinds of guangdong and tarpaulins custom make all kinds of finished products. Linyi tarpaulin factory to share with you about the tarpaulin folding method and the use of technology. Tarpaulin folding method: 1, tarpaulins positive upward flat rolled out, set aside two rope, the length direction of the longitudinal center line of two side bends to the tent. 2, will have folded on both sides of the third part, towards the midline even folded twice. 3, tarpaulins width of each side to tarpaulin lateral line fold, then each consecutive three times to the middle folded in half and steadfast. After folding shape size is about 1000 mm * 600 mm * 300 mm. 4, and use the reserved rope baling, two sides bundle of cross, tighten frap, rope head tucked up, should not be loose and rope buckle off, shall not delay. Should be complete clearly show after 5, folding tent on the small LuHui and tarpaulins number. Use requirement technology: 1, applies only to open wagon. A car film covering a tarpaulin. 2, tarpaulins, film covering flat, no goods the leakage. At the top of the ridge, Angle on both ends of the dense paste, smooth lines on both sides. Each part size is not overrun. 3, rope tied knot, bound to position correctly, the knot is firm, no slack off, on the t-bar cords with butterfly wings shape, rope head over the tail length 100 ~ 300 mm. 4, drooping tarpaulin cover freight car hand brake end end plate section length is 500 mm or less. Hand truck brake disc, brake disc and does not affect the hand hook rod is used. 5, vehicles on both sides of the tent prolapse highly consistent, car number appears. 7. 2 film covering method 6, tarpaulins, positive ( The waist line outward) Longitudinal film covering, waist line at the side of the platform. b) Angle rope tied: tarpaulins in each side 2 Angle rope tension respectively, make the tarpaulins Angle outward expansion into triangular shape. Cloth Angle after the two sides pressing bends to the truck end wall, in tight Angle on both ends of the vehicle, through the pressure line, hand hook or inside of the hand brake lever, the X taut, binding t-bar on opposite sides of the vehicle, respectively. 7, rope bound: tent rope, each side pressure should pin tarpaulins Angle taut, make the tent close to the vehicle side wall, bundled respectively on the vehicle lateral t-bar. 8, the rope tied: tarpaulins 2 per side side rope, should tighten convergent, through the mobile hook or hand brake lever, respectively, two vertical tied up at the end of the vehicle on the t-bar. 9, waist and rope tied: among vehicles have the t-bar, tent in the middle of the waist, rope tied up in the middle of the vehicle on the t-bar respectively; No t-bar among vehicles that covered more than knowledge provided by linyi tarpaulin factory, learn more knowledge to linyi tarpaulin factory's official website: tarpaulins, http://www. linyangpvc。 com